Decision Decisions

ashtaron14 · 06-10-2001, 01:29 PM

Ok, I finally took off the silver trim along the center console, now I've got 2 choices. Either I spray it with 51E paint (Aspen White) or I put the carbon fiber looking stickers on it... such a tough decision... Help Plz!

* Registered users of the site do not see these ads.

06-10-2001, 01:40 PM

Cast it and get trim pieces made out of real carbon fibre.

ashtaron14 · 06-10-2001, 01:51 PM

Well, I just did something very dumb... when I took the center console's vents out, there was a wire stuck pretty well to it... it was my alarm's LED... I tried to gently pull it off but it wouldn't budge, now I have no led to indicate that i got an alarm... So if I get an LED, I can just duct tape it to that same wire right?

alexs001: Great idea, if you can pay for it

ashtaron14 · 06-10-2001, 01:53 PM

One more question, how the heck do you take off the round vents on the sides next to the doors of both the driver's and passanger's side?

Thanks

Sunny

pro2cer604 · 06-10-2001, 03:51 PM

I don't know about you guys.. but i like the
silver panels, I even want to silver trim the door panels too... SERIOUSLY!

popnGEAR · 06-10-2001, 04:41 PM

ashtaron, i have my panels professionaly paitned that colour(i think), they were originally Syms'. We have different interior stylings but if you want to see waht white trim would look like we can meet up.

ashtaron14 · 06-10-2001, 05:41 PM

popnGEAR: ICQ'd you

06-10-2001, 06:07 PM

ashtaron14: Buy a blue LED from me, looks cool, very bright.

ashtaron14 · 06-10-2001, 06:46 PM

How much?

If it's like $10, no thanks...

06-11-2001, 08:23 AM

Actually, it's like $15. Mostly because it comes with a little strobe module, so all you have to do is hook it up.

Pretty useless if the line is already pulsing.

Blackskull · 06-11-2001, 10:29 AM

Get a blue superbright LED from an electronic parts store.... much cheaper than any vendor.

RP Electronics has them for around $6.

ashtaron14 · 06-11-2001, 10:32 AM

Actually, I think I had just lost the line... it fell into the dash... I'll have to see if I can find it... until then.. THANKS!

GS116 · 06-11-2001, 11:38 AM

Actually the center panel is not that hard to take it out, just need to be careful with those clips. And for the led wiring, if you can't dig it out, for sure you can tape it back together.

Fred

Devil_ChildAC · 06-11-2001, 01:46 PM

yo Sunny gat two red's for ya man...
so .... you can hook em up ..... one just in case you screw it up...... ( free )

AC

06-10-2001, 01:29 PM	#1
ashtaron14 Scooby Specialist Member#: 4674 Join Date: Mar 2001 Vehicle: 2004 Toyota Vitz Black Black Black!	Decision Decisions Ok, I finally took off the silver trim along the center console, now I've got 2 choices. Either I spray it with 51E paint (Aspen White) or I put the carbon fiber looking stickers on it... such a tough decision... Help Plz! * Registered users of the site do not see these ads.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
decisions decisions decisions	rudiger	Newbies & FAQs	33	06-17-2005 09:13 AM
Which Uppipe? Decisions, Decisions, Decisions!!	TheShadowWRX	Factory 2.0L Turbo Powertrain	11	02-07-2003 06:02 AM
decisions, decisions	NNeves	Tri-State Area Forum	3	04-06-2001 04:12 PM
decisions decisions	Rmak	General Forum Archive	5	12-04-2000 05:45 AM
OT: Decisions, decisions...	Duva	Mid Atlantic Impreza Club -- MAIC	2	09-29-2000 10:44 AM

06-10-2001, 01:40 PM	#2
alexs001 Guest Member#:	Cast it and get trim pieces made out of real carbon fibre.

06-10-2001, 01:51 PM	#3
ashtaron14 Scooby Specialist Member#: 4674 Join Date: Mar 2001 Vehicle: 2004 Toyota Vitz Black Black Black!	Well, I just did something very dumb... when I took the center console's vents out, there was a wire stuck pretty well to it... it was my alarm's LED... I tried to gently pull it off but it wouldn't budge, now I have no led to indicate that i got an alarm... So if I get an LED, I can just duct tape it to that same wire right? alexs001: Great idea, if you can pay for it

06-10-2001, 01:53 PM	#4
ashtaron14 Scooby Specialist Member#: 4674 Join Date: Mar 2001 Vehicle: 2004 Toyota Vitz Black Black Black!	One more question, how the heck do you take off the round vents on the sides next to the doors of both the driver's and passanger's side? Thanks Sunny

06-10-2001, 03:51 PM	#5
pro2cer604 Scooby Newbie Member#: 6191 Join Date: Apr 2001 Location: Abbotsford Vehicle: 2002 wrx Aspen	I don't know about you guys.. but i like the silver panels, I even want to silver trim the door panels too... SERIOUSLY!

06-10-2001, 04:41 PM	#6
popnGEAR Scooby Specialist Member#: 4616 Join Date: Mar 2001 Location: Bellevue, WA Vehicle: 1999 2.5RS RBP	ashtaron, i have my panels professionaly paitned that colour(i think), they were originally Syms'. We have different interior stylings but if you want to see waht white trim would look like we can meet up.

06-10-2001, 05:41 PM	#7
ashtaron14 Scooby Specialist Member#: 4674 Join Date: Mar 2001 Vehicle: 2004 Toyota Vitz Black Black Black!	popnGEAR: ICQ'd you

06-10-2001, 06:07 PM	#8
alexs001 Guest Member#:	ashtaron14: Buy a blue LED from me, looks cool, very bright.

06-10-2001, 06:46 PM	#9
ashtaron14 Scooby Specialist Member#: 4674 Join Date: Mar 2001 Vehicle: 2004 Toyota Vitz Black Black Black!	How much? If it's like $10, no thanks...

06-11-2001, 08:23 AM	#10
alexs001 Guest Member#:	Actually, it's like $15. Mostly because it comes with a little strobe module, so all you have to do is hook it up. Pretty useless if the line is already pulsing.

06-11-2001, 10:29 AM	#11
Blackskull Scooby Newbie Member#: 5616 Join Date: Apr 2001 Chapter/Region: VIC Location: Burnaby, BC Canada Vehicle: 2002 Impreza WRX Silver	Get a blue superbright LED from an electronic parts store.... much cheaper than any vendor. RP Electronics has them for around $6.

06-11-2001, 10:32 AM	#12
ashtaron14 Scooby Specialist Member#: 4674 Join Date: Mar 2001 Vehicle: 2004 Toyota Vitz Black Black Black!	Actually, I think I had just lost the line... it fell into the dash... I'll have to see if I can find it... until then.. THANKS!

06-11-2001, 11:38 AM	#13
GS116 Scooby Specialist Member#: 372 Join Date: Oct 1999 Location: Richmond, BC	Actually the center panel is not that hard to take it out, just need to be careful with those clips. And for the led wiring, if you can't dig it out, for sure you can tape it back together. Fred

06-11-2001, 01:46 PM	#14
Devil_ChildAC Scooby Newbie Member#: 5168 Join Date: Mar 2001 Location: Richmond	yo Sunny gat two red's for ya man... so .... you can hook em up ..... one just in case you screw it up...... ( free ) AC