Review Request: APS Uppipe

Sir_Xenon · 05-24-2003, 03:20 PM

Sounds like a good design for low and mid range, but what about top end? Anyone?

* Registered users of the site do not see these ads.

lobelsteve · 05-26-2003, 10:04 AM

Can't comment on the particulars of performance as I installed the APS uppipe, Invidia downpipe, and Greddy Evo all at once- combined they make a remarkable difference.

The APS uppipe is nicely constructed- though I do wish for a better finish on the flex pipe outlet. There were no instructions supplied with my uppipe and that would have helped greatly with the install. It comes complete with all mounting hardware.

http://members.cox.net/lobelsteve2

I posted pictures as above.

I'd get the APS or Autospeed with PDE flex after that.

IndySport · 06-16-2003, 01:45 PM

I installed an APS uppipe on my personal car this weekend and am REALLY happy with the final results. Very nice increase in power, no additional engine noise - I think the cast portion helps that out, no leaks. For anybody that thought that the two piece design would make the install easier - nope. We did two uppipes and a downpipe yesterday the other uppipe a single pipe Perrin, both went in about the same.

lobelsteve - I know what you mean about the finish of the outlet side of the flex pipe but I don't see any problems with it as air is flowing towards the turbo into the cast section.

Sir_xenon - I noticed a nice increase on the top end. It feels like it flows so much better. Stock setup felt like the car wanted to give up after 4500 rpm, it pretty much pulls all the way to redline with the new uppipe.

T33 · 06-26-2003, 10:16 AM

http://forums.nasioc.com/forums/show...ght=APS+uppipe

ghostfoot7 · 06-04-2008, 07:35 PM

hey john, check this thread out. I think it's the one i was talking to you about

http://forums.nasioc.com/forums/show...ght=APS+uppipe

05-24-2003, 03:20 PM	#1
Sir_Xenon Scooby Specialist Member Sales Rating: (0) Member#: 9666 Join Date: Aug 2001 Chapter/Region: E. Canada Location: Toronto Vehicle: 02 WRX Ver. 7 STi swap'd bugeye	Review Request: APS Uppipe Sounds like a good design for low and mid range, but what about top end? Anyone? * Registered users of the site do not see these ads.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Review Request: Intrax Products	Yukonart	Car Part Reviews	9	02-17-2005 01:22 PM
Review Request: APS Turbo Back Exhaust	TADpole	Car Part Reviews	2	08-25-2003 04:44 PM
Review Request: Cobb Catback for WRX	quynce	Car Part Reviews	4	08-08-2003 02:46 AM
Review Request: Gruppe-S Uppipe	SC WRX	Car Part Reviews	19	05-30-2003 01:26 AM
Review Request: HKS Hiper (high power) catback exhaust	M32WRXin3seconds	Car Part Reviews	1	05-27-2003 03:16 PM

05-26-2003, 10:04 AM	#2
lobelsteve Scooby Specialist Member Sales Rating: (3) Member#: 31992 Join Date: Jan 2003 Chapter/Region: South East Location: Canton GA Vehicle: 2007 STI UGM	Can't comment on the particulars of performance as I installed the APS uppipe, Invidia downpipe, and Greddy Evo all at once- combined they make a remarkable difference. The APS uppipe is nicely constructed- though I do wish for a better finish on the flex pipe outlet. There were no instructions supplied with my uppipe and that would have helped greatly with the install. It comes complete with all mounting hardware. http://members.cox.net/lobelsteve2 I posted pictures as above. I'd get the APS or Autospeed with PDE flex after that.

06-16-2003, 01:45 PM	#3
IndySport Vendor Vendor Sales Rating: (0) Member#: 35611 Join Date: Apr 2003 Location: Indianapolis, IN	I installed an APS uppipe on my personal car this weekend and am REALLY happy with the final results. Very nice increase in power, no additional engine noise - I think the cast portion helps that out, no leaks. For anybody that thought that the two piece design would make the install easier - nope. We did two uppipes and a downpipe yesterday the other uppipe a single pipe Perrin, both went in about the same. lobelsteve - I know what you mean about the finish of the outlet side of the flex pipe but I don't see any problems with it as air is flowing towards the turbo into the cast section. Sir_xenon - I noticed a nice increase on the top end. It feels like it flows so much better. Stock setup felt like the car wanted to give up after 4500 rpm, it pretty much pulls all the way to redline with the new uppipe.

06-26-2003, 10:16 AM	#4
T33 Scooby Specialist Member Sales Rating: (0) Member#: 30050 Join Date: Nov 2002 Vehicle: 2009 STI	http://forums.nasioc.com/forums/show...ght=APS+uppipe

06-04-2008, 07:35 PM	#5
ghostfoot7 Scooby Specialist Member Sales Rating: (3) Member#: 61040 Join Date: May 2004 Location: vancouver Vehicle: 2002 WRX dead sexy blue!	hey john, check this thread out. I think it's the one i was talking to you about http://forums.nasioc.com/forums/show...ght=APS+uppipe