|
|
|
|
Thread Tools | Display Modes |
08-12-2003, 10:09 PM | #1 |
Scooby Newbie
Member#: 41661
Join Date: Aug 2003
Location: San Francisco, CA
|
difference b/t manual and auto wiring harness
I've got a JDM ej20TT motor out of a '96 automatic and would like to fit it into a manual trans. Anyone know what I have to adapt or replace: wires, sensors, ECU? I'm guessing that it's just a matter of changing the ECU but maybe there's other differences I should be aware of.
Thanks. -ironmonkey57 San Francisco, CA
* Registered users of the site do not see these ads.
|
08-14-2003, 06:13 PM | #2 |
Scooby Newbie
Member#: 41661
Join Date: Aug 2003
Location: San Francisco, CA
|
jdm experience
Is there someone who might have some experience with the JDM engines? or knows at least of where I could buy an ECU for this type of engine?
Thanks again, -iron57 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
BULK dash wiring swap, Manual and Auto different? | ki11switch | Subaru Conversions | 2 | 09-21-2009 04:19 PM |
Any ideas of what's different between manual and auto ECUs? | Kha0S | Engine Management & Tuning | 1 | 09-07-2006 01:30 AM |
Ej20g into my 93, but comes with Auto wire harness? | my3awds | Subaru Conversions | 2 | 01-18-2006 05:31 PM |
Plug and Play wiring harness makes your wiring chores easy! | Mach V Dan | Engine/Power/Exhaust | 4 | 12-01-2004 04:02 PM |
differences in engines: manual and automatic | 2.5GT | Normally Aspirated Powertrain | 5 | 11-16-2001 12:04 PM |