|02-02-2001, 09:33 AM||#1|
Join Date: Mar 2000
Location: New England, United StatesVehicle:
2013 WRX Wagon
Autometer Elec. oil pressure gauge sending unit tap instructions
here it is tmat3, sorry for the delay.
now i used the retapping method and did not buy new fittings, remember to use TEFLON TAPE.
the hardest part of this is removing the alternator to get at the location, i believe that NorthUrsalia has the directions on removing the alternator on his website.
you can find a tap and most of the fittings including the T fitting at any plumbing store, and they will tell you how to use the tap if you ask (which is: insert, tighten by hand, then start the tap/thread with a wrench. NOT WITH A DRILL LIKE A DRILL BIT).
oh, and you don't need all those expensive AN fittings and hose. go to your local autoparts store and find a little kit for this particular application for a couple of bucks
[This message has been edited by joostin420 (edited February 16, 2001).]
* Registered users of the site do not see these ads.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Oil Pressure Guage sending unit.||05Scooby||Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo)||5||12-13-2007 05:32 PM|
|Autometer Cobalt Oil Pressure Gauge||Flat4inRC||Private 'For Sale' Classifieds||3||10-30-2004 09:15 PM|
|autometer ultralite oil pressure gauge (elec)||wongwayjoe||Electrical & Lighting||3||03-11-2004 01:13 PM|
|Autometer elec. oil psi gauge help||tranjo||Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo)||26||07-22-2002 11:54 PM|
|Autometer elec. oil pressure sending unit tap location instructions||joostin420||General Forum Archive||1||02-08-2001 10:39 AM|