|04-22-2005, 10:37 AM||#1|
Join Date: Nov 2004
Location: Marquette,mi areaVehicle:
09 WRX stg 2+
Lost the boxer rumble
Custom tune Warm cold boost problems
I just recently had a custom dyno tune on my 05 wrx stage 3 utec.
The temps were warm , 85 degrees It was tuned in 3rd to boost to 1.2 bar then settle around 16 psi.
It was great power was always there, i never got on the throttle in 4 gear till last night, however the air temp was 55 .
I got on the throttle on the interstate doing about 65 mph and the boost shot up to over 1.3 bar and i hit fuel cut which is 20.5 psi.
The abc control had to be turned out like 5 turns during the tune, But when i turn the abc control down I curb the boost in 4th gear but my 3 rd gear boost goes down too.
I'm waiting on the other place that tuned it to give me a answer , any suggestion to get full boost in 3 rd but not over boost in 4 th gear
I'm new to the utec , however i had no problems with this when i had the acces port
* Registered users of the site do not see these ads.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Weird problem after throwing a CEL + custom tune!||RaceTM||Engine Management & Tuning||9||09-16-2009 09:29 AM|
|Not Hitting Full Boost on Custom Tune||bulgarianfreak55||Engine Management & Tuning||1||07-28-2008 02:48 PM|
|HELP! Boost problem w/UTEC at tuning shop!||CreeeV15||UTEC||3||02-25-2007 01:30 PM|
|warm car start problems in cold||doofus||Service & Maintenance||2||02-15-2006 03:23 PM|
|boost problem after installing cold air.||dub976||Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo)||4||10-31-2001 05:24 PM|