anyone have a jdm v6 ej207 maf housing or need a maf sensor?

swapstar · 02-04-2006, 08:25 PM

im posting for a friend in need of a conversion part/advice/help

he needs the maf housing for a gc8 v6, or to find someone who needs a maf sensor. he has hte sensor but no housing to put it into. anynone know of a usdm part that is complatible wiht ver6 maf?

i would normally hook himup, but my extensive knowledge is only on the EJ20G stuff.

* Registered users of the site do not see these ads.

THAWA · 02-04-2006, 08:26 PM

Do you have a picture of the housing?

JeremyRS · 02-04-2006, 09:11 PM

If the ver 6 is the same as the ver 5 maf housing, then it doesnt cross over to a usdm part. I tried because to get one, cause mine has a small crack that I had to fix.

02-04-2006, 08:25 PM	#1
swapstar * Banned * Member#: 102779 Join Date: Dec 2005 Location: JDM land filling a container Vehicle: 1998 PM if u need JDM bits.....	anyone have a jdm v6 ej207 maf housing or need a maf sensor? im posting for a friend in need of a conversion part/advice/help he needs the maf housing for a gc8 v6, or to find someone who needs a maf sensor. he has hte sensor but no housing to put it into. anynone know of a usdm part that is complatible wiht ver6 maf? i would normally hook himup, but my extensive knowledge is only on the EJ20G stuff. * Registered users of the site do not see these ads.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Big MAF housing or intake for AVO full length inlet?	FCmaniac	Factory 2.5L Turbo Powertrain	0	05-15-2010 06:38 PM
have a teen driver in the house or know somebody who does?	Luke@tirerack	Mid West Subaru Owners Club Forum -- MWSOC	0	09-25-2009 10:45 AM
wtb: SSAC / CSS / or similar MAF housing or intake	Bad Noodle	Private 'Wanted' Classifieds	3	09-14-2009 03:35 PM
Does anyone have a TD06-20G with 7cm housing, clipped, & large wastegate flapper?	06slvrsti	Factory 2.5L Turbo Powertrain	17	05-01-2007 12:36 PM
Anyone have a mitsu turbo with 7cm housing	crazymikie	New England Impreza Club Forum -- NESIC	11	01-04-2007 03:39 PM

02-04-2006, 08:26 PM	#2
THAWA Scooby Specialist Member#: 44581 Join Date: Oct 2003 Chapter/Region: BAIC Location: Nor-Cal Ghetto Garage Vehicle: 3 Boxers 2 AWD 3 turbo 1 6cyl & a 13BT	Do you have a picture of the housing?

02-04-2006, 09:11 PM	#3
JeremyRS Scooby Specialist Member#: 65126 Join Date: Jun 2004 Chapter/Region: NESIC Location: Manchester NH Vehicle: 00 Leggy Wagon 99 Silverado, 06 HD	If the ver 6 is the same as the ver 5 maf housing, then it doesnt cross over to a usdm part. I tried because to get one, cause mine has a small crack that I had to fix.