View Single Post
Old 07-20-2005, 11:18 PM   #41
Scooby Newbie
Member#: 56885
Join Date: Mar 2004
Location: Kuwait
2000 IMPREZA Ra Blue
[email protected] bar

Thumbs up

Originally Posted by wgknestrick
I am having problems with leaks right now. I still have one intake leak with it leaking at the MAF sensor and multiple exaust leaks due to poor fitment of the Godspeed kit.

So far I have been having problems with most of the Godspeed Spec 650R pieces. The MAF hole is about .010" smaller than stock which causes the O-ring to bind up and not seal. And the EWG pipe fitment is poor causing a leak at the V-band flange because it is not square. Dan claimed that blow thru was the answer, but I cannot get the car to even idle with the MAF sensor plugged in on the stock ECU. I also have a ODB2 inspection in Dec! I am truely screwed. I will try to sort this out when I get back from vacation next week, but I am having problems.

At least it looks nice.....
Wishing you all the best luck to finish what you started and all pray for you too
I like the talent people doing the hard work and go over the limits
Hope to see every thing ok in the short future

* Registered users of the site do not see these ads.
bosaleh is offline   Reply With Quote