View Single Post
Old 12-21-2005, 07:53 PM   #103
Scooby Newbie
Member#: 88950
Join Date: Jun 2005
Location: Reston, VA
2003 MSP Protege`


Originally Posted by fmowry
1) Layer of raamat on the whole inside of the exterior shell of the door followed by ensolite on the whole inside of the exterior of the door.
2) not sure how Rick did this one.
3) I believe earlier in this thread or another he mentioned using self tapping screws to attached the aluminum.

Happily deadened via this thread
So the door would be like this:
outer shell | mat | foam | inner shell | mat | foam .... ?

So you cut the tin to shape over the holes, attach at a few points with self tapping screws, then mat over them. Do you use any type of material to put inbetween the tin and door shell?
* Registered users of the site do not see these ads.
livelyjay is offline   Reply With Quote