View Single Post
Old 04-13-2006, 07:41 PM   #13
Scooby Specialist
Member#: 12900
Join Date: Dec 2001
Location: Toronto, Ontario, Canada
1997 Legacy GT-Turbo
Quick Silver Metallic


Originally Posted by Kraziken
How much sanding did you do on the trim pieces and what grit did you use?

On the vents, especially near the front sides of the dash, do you just use a screwdriver and pry up a corner to lift it out?

I don't want to snap my plastic pieces.
I just did a light sand with very fine sandpaper, I think it was 1000 grit. Coat of flex primer, few coats of color, and a couple coats of clear.

The hardest pieces to remove were the ones you mentioned, front of dash on either side. They are held in by tabs so you have to be really careful.
* Registered users of the site do not see these ads.
Cajual is offline   Reply With Quote