Just finished up my Omori gauge install. Ordered them in December from Malaysia got 'em in January. They look like the dash gauges! I have the boost, oil temp, egt gauges. All the hardware from the face plate to the sensors are top notch! I was a little aprehensive about drilling into to my exhaust manifold but, I went ahead with it ( number 3 cyl). Just took the shield down and found the best place to drill and tap for it. Not too sure if I should of used a 1/8 bspt or not. That egt gauge is quick too. (rises with rpms) Omori gauges are black faced with green lights and yellow needles and I'm glad I chunked down the change for them. (course they had a special going in December). Any e-mails I sent to Michael Pang were responed to very quickly. (one was in just 2 hours! Thanks to all of you here at the I-Club. It's a great resourse!!!!