View Single Post
Old 02-08-2008, 12:17 AM   #59
Scooby Newbie
Member#: 67483
Join Date: Aug 2004
Location: Sacramento, CA
2005 WRX STi


Originally Posted by williaty View Post
I bet you could tell it to look at the entire data set, then select only the portion that was within one standard deviation of the minimum value (since in both IAT and dMAFv/dt we're selecting for low values).
I don't need it to weed out the data yet. just decide what the dmaf/dt cutoff should be.

Something related to standard deviation sounds like the right route. The 80/20 stuff might be a simpler version. Gonna go look into both methods. I'll take a peak into the ratio of used to discarded data from the manual mehod I did last time.
* Registered users of the site do not see these ads.
R4ND0M_AX3 is offline   Reply With Quote