View Single Post
Old 03-13-2009, 12:59 AM   #26
Scooby Specialist
Member#: 100449
Join Date: Nov 2005
Chapter/Region: SCIC
Location: NoHo
'04 WRX 307whp278tq
03WRX wgn, '72 MGB


So I mocked up the cardboard template under the car and here is the updated shape. I trimmed the template down a little on both front and back, and added a hole for access to oil filter and drain plug. The black dotted line is where I will bend up the metal approximately 6 degrees. It's not in the template but it is illustrated by the red line, I'm going to add a little edge that will be bent up vertically. Two pics here from both sides so you can see the new shape relative to the outline of the original splash guard.

* Registered users of the site do not see these ads.
OUScooby is offline   Reply With Quote