View Single Post
Old 07-11-2009, 09:06 PM   #5
Scooby Newbie
Member#: 216800
Join Date: Jul 2009
Chapter/Region: TXIC
Location: Houston, Tx
2004 WRX


Ok so $700 isn't bad. I would love to do it myself just don't have the tools to do it. Or place to do it.

I actually have a question to see if it is worth it. A rod bearing went out on the block that is on the car that is why I am changing the block. It should be fine if I just change the block correct???
Because one guy said it will just mess up again. I don't see how though.
* Registered users of the site do not see these ads.
brouib is offline   Reply With Quote