View Single Post
Old 12-19-2009, 12:35 PM   #80
Scooby Guru
Member#: 159243
Join Date: Sep 2007
Chapter/Region: Tri-State
Location: medford nj 08055
sg3 Turbo Tek Tuned
Hakt Ecu e85 30r 6spd


hey guys could someone go into discussion on how to run a mbc in conjuntion with a prodrive 3 port ebc? my tune is not complete but i am getting oscallation when trying to reach target boost 20#'s at 100% throttle. i have discussed this with friends who tell me i just need to speed more time adjusting the tune but i just want to understand how using a mbc can help me achieve and hold target boost at wot.

also, i'm getting backfire between shifts apparently due to 100% blow off valve. my cai/turbo inlet doesn't have a port for returning the air to the system with a recirculating bov but i am willing to weld one in...any suggestions on fixing the flames between shifts?
i don't want the attention and the popping is annoying. it is being caused by a rich condition due to loss of air in the system correct?

thanks guys. not trying to thread jack...just trying to keep a good thread informative.

* Registered users of the site do not see these ads.
maxpowr is offline   Reply With Quote