View Single Post
Old 01-20-2010, 01:53 PM   #12
Scooby Specialist
Member#: 203783
Join Date: Feb 2009
Chapter/Region: MWSOC
Location: Grand Rapids, MI
2005 LGT


Originally Posted by cooleys04 View Post
I ran a jumper wire from the battery to the flash block. I'll take a pic of where to connect it. Be back in a bit.

Ok, heres a pic. (sorry about the quality, the lock tab is facing upward) I used a lighter and melted the insulation off the wire so I could clip a jumper wire on it with an alligator clip, then ran it to the b+ terminal. I didn't have any problems flashing after that. Some people have said that they had to turn on accessories like the lights or blower motor to avoid a voltage too high error.
Cool, thank you! I'm looking to buy the cable in the next day or so. Hopefully it works well for me
* Registered users of the site do not see these ads.
SUBIESKI is offline   Reply With Quote