View Single Post
Old 05-03-2010, 10:22 PM   #116
Scooby Specialist
Member#: 165104
Join Date: Nov 2007
Chapter/Region: SCIC
Location: Riverside CA
E85 SoCalPorting


OK, Hi everyone just need advise/suggestions on how to at least reach a hit of 400whp on a dyno dynamics. My goal has always been to see a 400 whp # and so far I have always tried with only 91. I am throwing away my GT14 that only gave me 330 on 91 and changing to smaller TD05 20G 7cm2 which I plan on using higher octane/race gas on. Why, because I miss being able to drive my car on the streets LOL.

My mods are
04 STI swap engine, trans, rearend, axles,
TGV deletes
PE 850 injectors,
TD05 20G 7cm2 PNP/coated
APS 70mm CAI
APS 3 in inlet
Tomei unequal length headers
HKS EVC 6 boost controller
38mm waste gate
walbro 255
electronic 3in cutout
PNP throttle body
PNP intake manifold also Reversed
Custom FMIC for reversed mani
And at least 100 octane more if needed.
I am planning on getting a new block soon but am in no rush to let this one give the ghost. lol

Please let me know what else If anything I need to just see a SPIke of 400.

* Registered users of the site do not see these ads.
wrxsubiemod is offline   Reply With Quote