View Single Post
Old 10-22-2010, 11:35 PM   #6
john 1badSTI
Scooby Specialist
Member#: 77470
Join Date: Dec 2004
Chapter/Region: MWSOC
Location: grove city ohio
04 sti [email protected]
on [email protected] 30psi--spinning


When they machine the block for the sleeves they do not remove all the aluminum around the factory sleeve and the darton sleeve has to have a strong shelf to sit on at the top in the middle and at the bottom and if the cases are compromised in any of these areas the sleeve will not have the support to stay in place and will move around and drop.Like posted above you are better off buying a used block for 3 to 4 hundred and have it sleeved instead of using a block thats questionable.If you are trying to do a sleeved block by trying to save money by reusing your cracked block---FORGET IT.
* Registered users of the site do not see these ads.
john 1badSTI is offline   Reply With Quote