View Single Post
Old 11-10-2010, 08:50 PM   #18
Scooby Specialist
Member#: 52314
Join Date: Jan 2004
Chapter/Region: South East
Location: Following the green weenie
2002 PSM WRX 16G-XT
Dorothy from OZ, the XT


You mean you're not returning that wrench to Sears for a replacement?

Originally Posted by cjake39 View Post
This was my solution on Monday...

I was able to get two bolts out with a breaker bar and the right 10mm hex socket. The other two stripped the head out so we welded the hex socket to the bolt head that worked for one. The other one blew out the back of the socket, so a 3/4 wrench fit nicely over it....

We did have to use about a 4-5ft breaker bar. Some tools must be sacrificed for this job apparently. Heat from the welds did the most good to free it up.
* Registered users of the site do not see these ads.
340Duster is offline   Reply With Quote