View Single Post
Old 01-13-2011, 07:42 PM   #28
Scooby Specialist
Member#: 107076
Join Date: Feb 2006
Chapter/Region: MWSOC
Location: Richfield, Ohio
'06 WRX STi (WRB)
'06 Outback 2.5 (WGO/MGM)


Originally Posted by xabre1200 View Post
Can you take a picture of where you mounted it? I am thinking about moving my relay to reduce the wear and tear on it.
Pics as requested!

There are two threaded holes on the sheet metal which is the strut tower that were plugged up with plastic inserts. I removed the bottom insert and used that threaded hole to mount the relay. You can easily see the power and ground leads to the battery. (much closer and efficient now)

Close up of the relay:

And the routing of the horn signal wire and power to the horns through the engine bay and through the spacing between the headlight and grill area:

Final product (pic taken at an earlier date with lack of salt):

I simply grounded the 2 with an wire ring terminal to a ground point behind the hella mounting bracket. End thread hijack.
* Registered users of the site do not see these ads.
Jovver is offline   Reply With Quote