View Single Post
Old 03-22-2011, 03:17 PM   #13
Homemade WRX
Scooby Guru
Member#: 33782
Join Date: Mar 2003
Chapter/Region: MAIC
Location: Mooresville, NC
96 3MI Racing LLC
search FIRST, then PM!!!


Originally Posted by ansonowicz View Post
Not throwing any codes whatsoever. I'm using Subaru OEM master gasket set. It will cause one head to read less than the other? I didn't have the heads machined at all and they were still within spec using a straightedge.
decking the block pulls the heads closer together and alters timing. There are solutions other than juts thicker gaskets for solving the issue, now.

Originally Posted by wrspeed View Post
i would say to swap the solenoids from one side to the other and see if the problems moves to the other head...we had a car that did the same thing and turn out to be a bad solenoid.
I was going to say to do the same thing.
* Registered users of the site do not see these ads.
Homemade WRX is offline   Reply With Quote