View Single Post
Old 04-14-2011, 09:35 PM   #3
Scooby Specialist
Member#: 272675
Join Date: Feb 2011
Chapter/Region: NESIC
Location: West Haven, CT
2011 WRX
2002 Corvette Z06


I have described how to fix it multiple times on here and this is EXACTLY how I fixed it. Great pictures! The way the wire was routed through those clips put too much tension in the wire so I just unhooked it from the clips and that loosened it right up.

I can vouch for it working, I fixed it about 600 miles ago and it's still working great

By the way, a suggestion when doing this is to put your hazards on. That way you can constantly see how your turn signal is working as you are working on it. When I loosened the slack it didn't fix it at first, I also had to physically push the wires back into the bulb harness and then the bulb lit right back up to normal brightness
* Registered users of the site do not see these ads.
mrkyle3 is offline   Reply With Quote