View Single Post
Old 07-04-2011, 05:33 AM   #8
Scooby Newbie
Member#: 271529
Join Date: Jan 2011

After swapping fuel plates we started to build all of the fuel lines.

IMAG0013 by imprezagic, on Flickr

On the far right you can see an AN fitting that goes into the aeromotive fuel pressure regulator. The stainless steel lines are going into the turbo XS fuel rails.

IMAG0016 by imprezagic, on Flickr

For the TIAL Q BOV we tapped into the intake manifold for vaccum.

IMAG0017 by imprezagic, on Flickr

Fabbing up the intercooler and piping to work with the clocked turbo.

IMAG0042 by imprezagic, on Flickr

After starting the engine up and pulling the car out of the garage this is how it sat.

IMAG0045 by imprezagic, on Flickr

I forgot to mention that I bought seibon carbon wide body sedan fenders and 18x9 rotas

IMAG0027 by imprezagic, on Flickr

wheel fitment is a little wide...getting carbon rear fender flares in a couple of weeks

IMAG0020 by imprezagic, on Flickr
* Registered users of the site do not see these ads.

Last edited by e85monster; 07-04-2011 at 06:07 AM.
e85monster is offline   Reply With Quote