View Single Post
Old 08-15-2011, 08:51 PM   #17
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region: South East
Location: Lake Worth, Florida
2011 STI


Finally done with the wiring for the injector tank. Did a weather pack for the wires and a quick disconnect for the hose. This will allow me to remove the box without having to open the box while in the trunk.

April 12'

Here are my tank install picks. I did not screw down the tank straps yet but everything else is done.

I ran the straps underneath the foam corner piece. I scored a line further out on the trunk liner so I can fold it. I then cut a few slits in the score so that I can run the straps through it.

The trunk liner can now flap over and cover the foam piece.

Finished product. Looks like it all came OEM.

May 12'

DBA T2 rotors and Stoptech pads all the way around.

* Registered users of the site do not see these ads.

Last edited by jockeygolfs; 08-23-2012 at 05:44 AM.
jockeygolfs is offline   Reply With Quote