View Single Post
Old 08-23-2011, 10:27 PM   #114
Scooby Specialist
Member#: 280844
Join Date: Apr 2011
Chapter/Region: TXIC
Location: hEll Paso
2006 STi


FYI: You don't have to remove the wheel for this install method. Just lift the front right corner with the jack, and wedge your fingers around the wheel well plastic and pop it under the fender a little bit. It rests on 2 overhangs in the bottom outside of the fender. You pop it down a bit and it is flexible enough to just bend out of the way for a bit. Then just run your wiring through that plug that leads to the cabin.
* Registered users of the site do not see these ads.
gregroot198521 is offline   Reply With Quote