View Single Post
Old 11-06-2011, 09:09 PM   #42
Confucius37
Scooby Newbie
 
Member#: 291094
Join Date: Aug 2011
Chapter/Region: SCIC
Vehicle:
2011 WRX
SWP

Default

From what I read the Phillips "HIR" are the same spec as the Toshiba HIR bulbs, they just achieve the results differently. Phillips was able to get the same light output as the Toshiba bulbs without using the HIR coating. You can tell they are HIR if there is a thin film coating on the outside of the bulb.

Not sure about the HIR bulbs being ok for projector vs reflector, I'm not sure why that would be the case since most high beam setups are reflector housings anyway.

* Registered users of the site do not see these ads.
Confucius37 is offline   Reply With Quote