View Single Post
Old 02-09-2012, 10:05 PM   #21
Scooby Specialist
Member#: 173656
Join Date: Mar 2008
Location: Nashua NH

Originally Posted by manys View Post
Not to take anything from your idea BUT

The easiest(cheapest - no special tools required) way to take out piston pins is by PUNCHING them OUT , NOT PULLING OUT

I just use long 0.25" metal rod I bought for $3 at ACE and a mullet(hammer)

You slide it trough #1 pin to punch out #3 (and vice versa)
You slide it trough #2 pin to punch out#4 (and vice versa)

I didn't know that was possible, I would think that the inner CIR clips would be in the way of getting the rod through. But if it works, That is defiantly a good trick!
* Registered users of the site do not see these ads.
squarebush is offline   Reply With Quote