View Single Post
Old 02-10-2012, 04:34 AM   #27
Scooby Specialist
Member#: 148974
Join Date: May 2007
Chapter/Region: SCIC
Location: San Diego
2010 4x4 Silverado


Originally Posted by manys View Post
Not to take anything from your idea BUT

The easiest(cheapest - no special tools required) way to take out piston pins is by PUNCHING them OUT , NOT PULLING OUT

I just use long 0.25" metal rod I bought for $3 at ACE and a mullet(hammer)

You slide it trough #1 pin to punch out #3 (and vice versa)
You slide it trough #2 pin to punch out#4 (and vice versa)
I was under the impression that this was the norm... so much easier to pull out if the pins aren't stuck. Don't have to deal with a c-clip turned just enough to be in the way, or having to move a rod out of the way.
* Registered users of the site do not see these ads.
SurfGuruJeff is offline   Reply With Quote