View Single Post
Old 04-11-2012, 02:30 PM   #42
Scooby Newbie
Member#: 204178
Join Date: Feb 2009
Chapter/Region: International
Location: Petacciato, Italy
2006 STi


i understand about all the time it takes for one to make something that may come out looking like ass, but at the same time youre buying $160 pieces of flat plastic and from what you guys have said, dont even last.

Originally Posted by vision.dynamix View Post
RallyArmor's printed logo, on the other hand, will fade, or chip off.
Originally Posted by Macross View Post
Didn't rip like the RA URs did.
Originally Posted by P_tothe_G View Post
Not sure about long term strength, there are 1,000's of blends of plastics/foams/rubbers. I would think if there is a failure, it is because the mounting holes are too close to the exterior edge of the flap. Price wise, both are cheap for using urethane, raw stock of the good stuff is pretty pricey. I have the RA ur, and they do the job.....only thing is that when shipped to me, they came one of my rear flaps is tailing back, and the other is curved forward....not so appealing
Originally Posted by Macross View Post
1. It won't come out as clean since I don't have the cutting tools to cut the shape and make the proper holes. (DRT have clean edges compared to RAs too)

im not trying to tell you guys how to spend your money. im just saying i personally think $160 is steep for such a product.

mod away!
* Registered users of the site do not see these ads.
itsbert is offline   Reply With Quote