View Single Post
Old 05-18-2012, 02:52 PM   #160
Scooby Specialist
Member#: 18440
Join Date: May 2002
Chapter/Region: SCIC
Location: so cal
2004 WRX Wagon
Always need moar grip!


So I ordered the FEP Viton® Fluoroelastomer O-rings. Installed them and...Not so much!

These rings may have some great stats but are not adequate for the rebuild.

I have ordered the same ones as the OP and will be doing it again. Side note the rebuild including pressing out the bearing and seal and replacing them isn't that bad.

Also I ordered the shaft seal from Rocket Seals matched to the OEM seal fairly well and pressed in great and was a great seal around the prop shaft for what I can tell with it all disassembled...
* Registered users of the site do not see these ads.
othon is offline   Reply With Quote