View Single Post
Old 06-04-2012, 03:16 PM   #1
NASIOC Manufacturer
Vendor Sales Rating: (10)
Member#: 6776
Join Date: May 2001
Chapter/Region: NWIC
Default NEW Endlinks From PERRIN Performance

> NEW! Endlinks From PERRIN Performance <

PERRIN Sway bar endlinks are machined from solid 6061T6 aluminum and use our custom polyurethane bushings. The low profile design of PERRIN endlinks allow for ample clearance for even the largest diameter sway bars. Polyurethane bushings are a great alternative to someone wanting the race car type part, without the added maintenance or harshness of a spherical bearing type endlinks.

PERRIN endlinks feature 95a durometer custom made polyurethane bushings. We choose a stiff 95a durometer material to provide a feel similar to a solid spherical bearing endlink but without the harshness or noise that can be associated with them after years of use. Polyurethane is extremely durable, nearly maintenance free and less expensive then bearing type endlinks.

PERRIN polyurethane bushing endlinks were designed for those living in climates where your vehicle is commonly exposed to corrosive elements. The combination of aluminum, polyurethane, and yellow zinc plated hardware make PERRIN performance endlinks very weather resistant and unaffected by wet climates and road salt.

PERRIN Performance warrants to the original purchaser, all PERRIN products to be free from defects in material and workmanship within a sixty (60) months period from the date of purchase. *Some exclusions apply

The polyurethane cost less to make vs. the spherical bearings so you pay less.

Click your car below to check them out on the PERRIN web site.
> 2004-2007 STI
> 2002-2007 WRX
> 2008-2012 STI
> 2008-2012 WRX

* Registered users of the site do not see these ads.

Last edited by PERRIN; 06-04-2012 at 03:44 PM.
PERRIN is offline   Reply With Quote