View Single Post
Old 06-23-2012, 11:58 PM   #12877
Scooby Specialist
Member#: 302491
Join Date: Nov 2011
Chapter/Region: Tri-State
Location: Buffalo, NY
2012 Impreza 2.0i Pr
Dark Grey Metallic CVT


Originally Posted by sgoldste01

I know it should be intuitively obvious, but how did you go about removing the trim pieces? Where did you find it easiest to start prying out the trim? What tool did you use, if any?

It should be easy, but I'm something of a bull in a china shop when it comes to removing plastic snap-in trim, and generally end up breaking something in the process.
I was able to pry them off very easily. I started from the thinned out top, outside corner... got my fingers in there & they came off easily. Popped right back on in a snap too.

Originally Posted by SleepNMnky
put the fog overlays on. bought them on ebay pre-cut, $7.99 free shipping from US seller. came with 3 in case you make a mistake on one.

my first time working with the vinyl & up close they're not perfect, but i think i did alright. i will say, you may want to go with the option to buy a sheet & cut them yourself. with the pre-cut, there's not much wiggle room & if they shift even slightly during application you may have an exposed edge, so if you can cut them just a hair too big you'll have a small lip to apply around the edge if you need to.
* Registered users of the site do not see these ads.
SleepNMnky is offline   Reply With Quote