View Single Post
Old 07-18-2012, 07:03 PM   #26
Scooby Guru
Member#: 108051
Join Date: Feb 2006
Chapter/Region: Tri-State
Location: NY
2005 TickingTimeBomb
Jr tuned TT Sleeved


Well I've been driving the car fixed couple boost leaks. throttle body gasket. Just ditched the down pipe gasket junk.

Hopefully I can drive it and get the o2 sensor ready and the evap isn't ready I'm over due for inspection. I did delete the evap solenoid when I had the hydra.

I Put 400 miles on the car this post weekend. The motor is great no smoking on start up or at all catch can hardly has anything in it. Tony did a great job.

I already have my spare block ready for him to do if possible.

Besides that if anyone has any input on getting it ready for inspection that would be helpful. the o2 sensors are original but where removed for the two years the hydra was in the car.

They seem to be moving normally while driving. I'm hoping it was just because my coupler leak, throttle body gasket, and down pipe gasket that caused those systems not to ready at least the o2 sensor the heater is ready.
* Registered users of the site do not see these ads.
spoolinsti05 is offline   Reply With Quote