View Single Post
Old 08-12-2012, 02:38 AM   #37
Scooby Specialist
Member#: 89599
Join Date: Jun 2005
Chapter/Region: RMIC
Location: middle of nowhere, wyoming
1995 almost 22B:)


Been working hard on the car. The last big main thing I have to worry about is a new driveline and I am considering having a one piece unit made.

I replaced the harness bar. I raised it up about 4 inches and with the seats installed it brings the angle of the harness to 3&5* for driver/co-driver.

Made a battery mount behind my seat.

New pedal box mount is built and in the car but I don't have pictures.

Looking to mount the hydraulic handbrake in the next day or two and this is about the only place that doesn't interfere with the shifter and feels good. It looks close to the navi seat but it's not bad. Anyone see anything I am not with this placement?

Quick question on seam welding. Those who have done it, do you do the fender seams inside the car and in the wheel well or is it one or the other?
* Registered users of the site do not see these ads.
bmxpunk is offline   Reply With Quote