View Single Post
Old 10-03-2012, 08:36 PM   #212
Scooby Specialist
Member#: 272090
Join Date: Jan 2011

did the bedliner and pressed in the group n bushings on the trailing arms, shifter stuff, trans mounting brackets and lateral links.

had to cut out one of the sway bar brackets and re weld a nut... PIA

funny story behind this one.... i was tearing down one of our ecotec motors today for a build when lone behind i picked the cam gear i set on the ground up and this was left... hope this is a good sign
* Registered users of the site do not see these ads.
omiotek is offline   Reply With Quote