View Single Post
Old 10-26-2012, 01:54 PM   #2300
shamrock 05
Scooby Guru
Member#: 120057
Join Date: Jul 2006
Chapter/Region: MWSOC
Location: *outskirts of motor city*
2018 WRX (base) 6spd


Cobb will never be Prodrive.......

However, on the prodrive lip I heard that when you bought the original lip, it came with some type of glue to adhere to the center section of the bumper......what kind of glue can I use to make sure it stays inplace and can anyone post the prodrive instructions about gluing this lip in place?

It would be appreciated, thanks.

And if someone knows a place to buy a "good" ProD lip let me know. I bought one and the fitment was so tight it was impossible to put on. U mount it in the fender wells first then pull it up towards the center, but its like the lip was too small.
* Registered users of the site do not see these ads.

Last edited by shamrock 05; 10-26-2012 at 02:01 PM.
shamrock 05 is offline   Reply With Quote