View Single Post
Old 10-29-2012, 05:32 AM   #102
Scooby Specialist
Member#: 274205
Join Date: Feb 2011
Chapter/Region: SWIC
Location: Mesa, AZ
2013 XV Crosstrek


Originally Posted by mechatricity View Post
Then I think you need to take a deep breath and rewrite your post.
Maybe i am just over thinking this. I was very frustrated. It also didnt help that my buddy that was helping me wasnt much help at all.

I am going to describe how i see the installation going thru my head:

1. bolt one side of the flare the the fender on the car.

question: do i need to make any cuts in the flare to make it a bit more flexible or can i just pull on it?

question 2" where can i zip tie the flare to?

question 3: Jimbo, did you drill into the fender on your car?

2. drill holes into the fender at the top so to secure the top portion of the flare.

3. bolt down other end of flare.

question: what if there are gaps or bulges? what did you do to fix that?

Is this all there is to it or am i missing something?
* Registered users of the site do not see these ads.
Daddy_Digital is offline   Reply With Quote