View Single Post
Old 10-31-2012, 06:47 PM   #8
Scooby Specialist
Member#: 281811
Join Date: May 2011
Chapter/Region: NESIC
Location: Vermont
04 WRX
World Rally Blue


Originally Posted by Bo0stin5STI
I did it with the engine out of my car.

I would look around for a Factory Service Manual. That's what I consulted when I did mine. Also contains torque specs! Since you're tightening into aluminum, I wouldn't want to over torque!

Also, may I ask why are you swapping pans?

As far as gasket is concerned call your local dealer for that. I believe it is a special RTV (at least it is on my 05) that's not too expensive!

Probably take .5 to 1.0 hours taking your time and cleaning all of the surfaces (if you're mechanically inclined)

Good Luck!
Same here. There is no rubber gasket, if I remember correctly I just used Permatex's "The Right Stuff".
* Registered users of the site do not see these ads.
emazz104 is offline   Reply With Quote