View Single Post
Old 11-08-2012, 11:57 AM   #22
Scooby Guru
Member#: 133146
Join Date: Nov 2006
Location: SC
07 FPgreen [email protected]
WRX VF39+E85 12.0, 121mph


Originally Posted by wrxsubiemod View Post
Agreed. Are you seeing any limitations with the tmic at this point? E85 helps. I'm sure you get asked this a lot and apologize a head of time. Looking good
As far as I know no! although I wan't to replace the TMIC with ETS core because my hyperflow TMIC fits like crap. Np

Originally Posted by Equilibrium Tuning View Post
About 420-430whp sounds about right. Could you do a pull in 3rd? I'm curious to see where your torque peak would end up.

No doubt you have some nice spool from the TMIC, small header and hot side, but I think those will be quite a bit of restriction it you try to push it much more. You will run into MBT much earlier from the increased back pressure.

This would be better compared to the GTX3071 we built a while back that did 440whp on a TMIC at about 25psi. That car hit peak torque at 4k RPM in 4th gear on the dyno (07+ gearing).

-- Ed
Yeah I can get a 3rd gear plot, either tomorrow aftenoon or friday.
Agreed the hotside is the restriction right now. That GTX3071 was running a EWG which if I ever decide to get one will help a lot 15-25whp.
* Registered users of the site do not see these ads.
juanmedina is offline   Reply With Quote