View Single Post
Old 11-15-2012, 04:17 PM   #16
Add Lightness
Member#: 13699
Join Date: Dec 2001
Chapter/Region: NESIC
Location: Hopkinton, MA

Ok, I cleaned this up a little.

OP, I don't know the answer, but you say you have an invoice. Do you have the source of that invoice? Is it a shop or a parts importer? I would think that that would have the info to get you a phone number and call and ask.

There are some pieces of info here. You might not know without pulling the engine apart and looking at the block.....which would be ridiculous to do.

Do some research. Are there different casting marks? Hints pulling the oil pan? I don't know.....
* Registered users of the site do not see these ads.
Jack is offline   Reply With Quote