View Single Post
Old 02-06-2013, 09:02 PM   #432
NASIOC Supporter
Member#: 195711
Join Date: Nov 2008
Chapter/Region: MWSOC
Location: Lapeer MI
02-07 Goodies


99.99% done. I want to change out my Bosch sensor to see if that will fix the gauge being off since I have an extra anyways, It is really annoying having it be off like this, and at this point, I dont want to have to install an innovate, that would be really annoying too.

Other than that, got oil changed today, EBCS plumbed in, and my knockblock all situated, ended up dropping the gain on it a bit cause at 4 it was a little high doing the test that you're supposed to do ( 1-2 volts with frequency turned off and @ 3,500 RPMs )

If I am feeling ambitious, I might swap plugs, but after 1000 miles, I doubt there is anything wrong with the ones I have. Anyone have a comment about my carpet question?

What about how much gas to have in the tank when you go to get tuned. I was at 1/3 and dumped 5 gallons in, and apparently it was fuller than I thought, now it is almost full.

If needed, I can empty some out, that wouldn't be hard.
* Registered users of the site do not see these ads.
Layvon is offline   Reply With Quote