View Single Post
Old 02-08-2013, 05:34 PM   #7
Scooby Specialist
Member#: 273906
Join Date: Feb 2011
Chapter/Region: NESIC
Location: Romance
Meow Gravel Grinder
Cadence @ 120 HowBow dah


Originally Posted by JonnyV2889 View Post
Not sure where you are. If you want to drive it to nh...hah
I could send the material to you if necessary. Specifically, I would like a piece of 3/4" diameter metal rod with a groove for a snap ring at one end. The rod doesn't need to be more than 1-2" in length. I need it for testing purposes, and if it works out then I would like to commission someone to make a small run of a final product. The final product would be 2" in length, 3/4" diameter, and would have 3-4 snap ring grooves at one end, spaced about 3/16" or 1/4" apart. Depending on price, I'd probably want 25-50 of them to start. Edit: And the final material would preferably be aluminum or brass.

I will edit the original post to include this information...I wrote that post at 2am and I was.
* Registered users of the site do not see these ads.
tibug is offline   Reply With Quote