View Single Post
Old 02-10-2013, 01:07 PM   #9
Scooby Specialist
Member#: 42548
Join Date: Aug 2003
Chapter/Region: NWIC
Location: Portland, OR
1999 GF8 V7 STi Swap
Aspen White


While you can adjust them up/down + left/right this will NEVER fix the problem you have which is the RHD beam pattern. If you adjust them as much as you can to not blind oncoming traffic the light output on the road for your use is next to nothing.

You'll have to acquire a LHD beam pattern insert off ebay (or somewhere else but I found mine there) and take apart the headlights to install it.

It's a time consuming process but not hard if you have all the tools. I used a heat gun instead of baking them because I didn't want to risk ruining my expensive headlights.

Once the piece is installed into the projector housing you reverse the process and then plug them up with a lightwerkz wiring unit and you're done.

You'll be much happier with the light output and all other drivers on the road will thank you for not blinding them.
* Registered users of the site do not see these ads.
hail2theTheif is offline   Reply With Quote