View Single Post
Old 03-27-2013, 05:42 PM   #4776
Scooby Guru
Member#: 48219
Join Date: Nov 2003
Chapter/Region: MAIC
Location: Pittsburgh, PA
. Always drive
the race line .


Where can I buy the male and female parts to make a good weather resistant connector assembly? I need to make a few 2 pin connector assemblies.

Mike, I know you had mentioned getting the Metripack stuff. Do you need any special tools to assemble them? Is Ballengers the best place to get them still? Anything local?

Should I just buy a set of these?
Should I get this crimping tool too?

* Registered users of the site do not see these ads.

Last edited by MRF582; 03-27-2013 at 05:52 PM.
MRF582 is offline   Reply With Quote