View Single Post
Old 04-09-2014, 02:25 AM   #169
Subie_Noob_Brian
Scooby Specialist
 
Member#: 288037
Join Date: Jul 2011
Chapter/Region: NWIC
Location: University Place, WA
Vehicle:
2015 LightingRed WRX
11' WRX sold**14' XV sold

Default

Sub And Amp Install!

Today I took about 2.5 hours at least to pull apart the entire passenger side of the car basically. I removed the glovebox, the plastic behind the glovebox, all trim around the doors, front seat, rear seat, seatbelt trim, lifted carpet, and more.

I made a very very small cut into the gasket in the firewall to run the power wire. I forced the wire through to keep an air tight seal. I still want to reroute the power wire in the engine bay, but thats an easy fix by disconnecting it from the battery. Right now it looks good except where it enters the firewall.

No wires are visible and everything is under the passenger side carpet. The sub box was build for my crosstrek to stand up, but it doesn't fit in the WRX standing up. Its also up against the carpet in the trunk and the trunk barely fits.

The most important thing is to take your time removing trim to avoid braking anything!









* Registered users of the site do not see these ads.

Last edited by Subie_Noob_Brian; 04-09-2014 at 02:41 AM.
Subie_Noob_Brian is offline   Reply With Quote