View Single Post
Old 07-22-2014, 06:24 PM   #1
clamsjager
Scooby Newbie
 
Member#: 172787
Join Date: Feb 2008
Chapter/Region: NESIC
Location: Waterford ct
Vehicle:
2008 Impreza wrx
Dark Grey

Default DIY: 2015 sti blinkers on wrx.

For detailed install instructions and harness purchase for this mod visit defroy.org, most of the info from this post is there and more.

Figured I would see if it were possible to put the sti blinker and caps on my wrx, well they fit, though there is no wiring for the blinkers.

Parts you will need to order:
Lamp assy turn sdlh 84401aj010
Lamp assy turn sdrh 84401aj000

Cover cap repair lh 91059va030
Cover cap repair rh 91059va020

Will also need screws 4 of them, I'll add part numbers when they come in.



First you will need to pry your stock mirror apart.


Take a pry tool and wiggle it between the upper and lower side part of mirror.


Pull the bottom trim off carefully then peel up the painted part till it snaps off.


Mirror is apart, can take a peek inside but I didn't see anything to connect the led signal to.




Video picks up after this point, Don't make fun of me im still learning GoPro studio. Also sorry for the no music or anything, could not figure that part out.

https://www.youtube.com/watch?v=iqtSpJerlIY

this is where it stops for now, will finish once all parts and I figured out wiring. Here's some pics as a tease.



* Registered users of the site do not see these ads.

Last edited by clamsjager; 10-15-2014 at 03:39 PM.
clamsjager is offline   Reply With Quote