View Single Post
Old 06-03-2010, 11:09 PM   #132
MannyMohawk#5
Scooby Specialist
 
Member#: 98807
Join Date: Oct 2005
Chapter/Region: SCIC
Location: The Mullet Mafia
Vehicle:
1999 RSTi
RHD BF5 & BJ6

Default

Quote:
Originally Posted by dub c View Post
Help!
I'm trying to install the fender arches.
I drilled the holes but I'm having a hard time clipping the pieces in!
For those who have done this, is drilling through the body panel and the wheel well panel necessary?
I'm stumped.

P.s. Thanks for the write up Adrenalin Rush!
Quote:
Originally Posted by (bOOsted) View Post
damn you have some balls drilling threw your car like that lol
You don't have to drill holes into your car to install these. I still don't understand why people do it that way. All I did was snap of the clips from the back of the arches except for the lower two (where there are already holes in the body) and used the tape to hold them on. Worked great for many years, and no extra permanent holes in the side of the car.
* Registered users of the site do not see these ads.
MannyMohawk#5 is offline   Reply With Quote