View Single Post
Old 06-22-2019, 08:48 AM   #15
Dibaltic
Scooby Newbie
 
Member#: 485271
Join Date: Apr 2018
Chapter/Region: MAIC
Location: Pennsylvania
Vehicle:
2003 Forester
Red

Default

Quote:
Originally Posted by Stoned_sti View Post
What's going on Momosaurus,

I've just finished this same project, I've got 1 final issue I'm having a hard time getting an answer to, so I'm thankful of finding this thread. So thanks.

What drive shaft did you use for this swap? I'm having an angle issue from the legacy driveshaft that I originally had used, the bracket that holds the current bearing on the driveshaft sits to low. If you had a part# or what model the driveshaft came off of, you'd help me with the final piece to my puzzle 🙏
I appreciate the help in advance

I'm Ryan by the way✌️
The OP last logged on 5-21-14 I doubt he'll see your message.
* Registered users of the site do not see these ads.
Dibaltic is offline   Reply With Quote