View Single Post
Old 06-08-2009, 02:48 PM   #14
chimchimm5
Scooby Guru
 
Member#: 88501
Join Date: Jun 2005
Chapter/Region: BAIC
Location: NorCal
Vehicle:
2011 WRX Hatch
Dark Grey

Default

I used a glove with rubber palm and grabbed the shaft (ala TIC's tip) and used a light duty impact driver and got the nut "finger tight-ish" just to hold the top hat and assembly in place. This worked fine and I torqued after they were on the car.



But I also have Ohlins which has adjusters on the bottom of the strut so the shaft at the top is not hollow.
* Registered users of the site do not see these ads.
chimchimm5 is offline   Reply With Quote