View Single Post
Old 12-12-2017, 01:28 PM   #1
KNS Brakes
NASIOC Vendor
 
Member#: 125739
Join Date: Sep 2006
Chapter/Region: South East
Location: Raleigh, NC
Vehicle:
2007 1500HD
Need Brakes? 919.420.0021

Default 2018 STI Brembo Brakes

The pads and rotors used on the 2018 STI are confirmed now so we can prepare for next year. It will take a while to have reasonable parts for these brakes.

I am going to have GiroDisc make 2 piece front and rear rotors.
UPDATE - WE CAN ONLY MAKE FRONTS. REARS WOULD REQUIRE A SHORTER PAD OR GRINDING A LOT OF THE STOCK PAD. NO BUENO

I am going to have DBA make KNS rotors.

UPDATE - ALL SYSTEMS GO - CALL ME IN THE FALL!

Pad choices will be OK - fronts are already out but rears are going to take a bit.
UPDATE - REAR PADS ARE ALL NEW BUT WE SHOULD HAVE THEM IN FEBRUARY



I need to get a set of brake lines as well.
DAMMIT _ AM I GOING TO HAVE TO BUY THOSE TOO?

Rotors

Front - 340mmx30mm and drilled -24.5 pounds. Pad Annulus = 59mm.

The overall height is 54mm but my measurement of that was crude. Just a small change there.

Nice black finish though


Rotors

Rear - 326mmx20mm and drilled -17.5 pounds. Pad Annulus = 54mm.

The overall height is 63.5mm which appears to be unchanged.

Nice black finish though


Front Pads


Rear Pads
It's ALMOST but not quite this.
* Registered users of the site do not see these ads.

Last edited by KNS Brakes; 01-11-2018 at 12:56 PM.
KNS Brakes is offline   Reply With Quote