View Single Post
Old 10-06-2012, 12:04 AM   #1
Jkmaynard
Scooby Specialist
 
Member#: 155178
Join Date: Jul 2007
Chapter/Region: NWIC
Location: Tualatin OR
Vehicle:
2004 435 WHP EVO 8
Nasty silver

Default so a few questions about building my block

I just got the full results back on my leakdown test and 4th cyl ringland is toast so what i an asking i am looking at doing forged pistons i would like to get to 350 whp..

I am guessing it would be wise to do rods also anything else i should do also while i am in there i teally dont want to do sleeves i was told ther would be no need for them at the goals i want to make bit just wanting some oppions...

also i have worked on lots of motors but never torn into a boxer engine before so i would to do it myself to save some cash to throw towards a bicer turbo...
Shoot anything at my like what pistons rods do you guys like CP i here makes good pistons never looked into there rods
* Registered users of the site do not see these ads.
Jkmaynard is offline   Reply With Quote